Authors: Arpita Sunil Kale, Dr. T. Y. Badgujar
Abstract: The piston is one of the most heavily loaded components of an internal combustion (IC) engine, since it must withstand cyclic gas pressure, steep thermal gradients and high reciprocating speeds. This paper presents the design and finite element analysis (FEA) of a piston for a single-cylinder, four-stroke engine with a 50 mm bore and 49.5 mm stroke. A three-dimensional model containing a concave crown, three ring grooves, gudgeon-pin bosses, internal ribs and fillets was developed in Autodesk Fusion 360 and analysed in ANSYS Workbench. Static structural analysis under a peak gas pressure of 5 MPa and steady-state thermal analysis were carried out for three candidate materials: an aluminium alloy, AISI 316 stainless steel (SS316) and the additively manufacturable alloy AlSi10Mg. The equivalent stress was almost material independent (169.7–184.8 MPa), whereas SS316 reduced the maximum deformation from 0.224 mm (aluminium) to 0.085 mm and lowered the peak total heat flux from 254.6 to 39.2 W/mm2. A hand calculation based on strength of materials reproduced the FEA stress within 0.5% and the same material ranking, which validates the load path and boundary conditions of the model. The results show that SS316 gives the greatest stiffness and the lowest heat rejection through the crown, while the aluminium alloys retain the advantage of low mass; the trade-offs are discussed to guide material selection.